Messages

Cob,  sent you a PM about some driveshaft weights.

I'm in need of one too

$400.  Local pickup.  45 minutes west of Ft Worth.  PM if interested

Bare metal is 1.75"
Rubber coated area is 2.00 - 2.15

Bill, PM sent

One option is to contact Brent Lykins and let him specify and source you a custom cam.  Cost will not be much (if any) more than an off the shelf cam .  He's a Comp cams vendor.  He's well respected on FE engine forums.   Comp will grind cam per his spec and drop ship directly to you.  I've typically received custom camshafts thru brent in 7-10 days.   Lykinsmotorsports.com

Brent has quite a few youtube dyno videos that are fun and informative to watch.

Photo of my 2/26/69 build.  Original quarters and metal back there.

Yep.  That's where the one in my photo came from

more

more photos

more photos

I'd like to hear expert opinions about the antenna in these photos.  Specifically the antenna that i've labeled as "maybe original".    The other antenna in the photos i recently bought from ebay vendor that routinely sells inoperative (but nice) version of the original.   Also i'd like to hear opinions re: the coax cable.   Thanks

The number on headlight bucket can be seen in this photo during disassembly.   Now that this area of my car is assembled,  i can reach up and feel the embossed numbers but they aren't visible.

My valance has S9ms number on the backside of where i show the blue tape in my photo.

Where on the truck lid did you find numbers

Are you referring to any particular part(s) ?   The unique shelby part numbers are easy to find on the hood, front fenders and front valance.  The part numbers have S9MS prefix.   

In the photos i post,  the number is found on opposite side of the blue tape.

The numbers on the headlight buckets aren't visible unless part is off the car. 

I don't see a part number on my trunk lid nor on my taillight panel. 

if you post pictures of parts (especially the backside),  folks on this site can identify reproduction parts

Is there a preferred insulation/sealer product that folks are using to spray the firewall per the application discussed in this thread ?