News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - 6s1461

#1
NPD  >:(
#2
Put  ohm meter to new to new harness and there is no continuity. Also did the same check on the old harness and they are good.
#3
Just hooked up the original headlight harness to the battery side of the starter solenoid , then grounded the three eyelets . I got a small voltage reading  at the firewall plug. What do you guys think?
#4
I just unplugged the headlight harness at the fire wall.
I figured the black/yellow wire is the main feed for power from looking at my diagrams.
Tested with a volt meter, no power at the firewall plug on the black/yellow wire or any other wires for that matter.
#5
Ok will check that this afternoon.
The friend that helped fire up the car said , has had the repo hardness w the wires at the plug be in the wrong position. Has any body seen that also
#6
SAAC Forum Discussion Area / Just fired Up K code
June 13, 2023, 11:34:06 PM
We fired up the hipo  coupe, however we had to hot wire it.
There is no power at the dash, no instruments, no courtesy lights.
Checked the voltage at fuse box nothing.
All the harnesses are new repoductions.
Where do I go from there?
Thanks
#7
SAAC Forum Discussion Area / Wiring question
May 29, 2023, 06:05:19 PM
I am putting together a 65 K gt coupe. The reproduction wiring harness has two blue/black stripe wires w eyelets that hang out of the harness. They are located just before the firewall under the dash, where goes to the engine feed. Out of curiosity i found wires on the original harness folded back and buried under the original black tape. I have no idea what they are used for does any body know?
#8
I am restoring a 65 K GT coupe. Looking for an original starter and details for the the drive shaft.
#9
Parts For Sale / Hipo carb C6ZF C
September 03, 2020, 10:49:38 AM
66 hipo carb
Complete in great condition.
I can text or email pictures
$2000
Bruce
#10
Parts For Sale / KH Rear brake drums And baking plates
August 17, 2020, 10:41:57 AM
Original brake drums almost like new. 10.008
Backing plates have been repaired No groves.
Theses are ready to go. $1300
I can text pictures
#11
SAAC Forum Discussion Area / New gt500
June 28, 2020, 10:49:49 AM
Has any bought the new gt500, if so what are people paying?
#12
Both are 70859
#13
Parts For Sale / Rear brake drums and backing plate
June 12, 2020, 08:54:52 PM
I have set KH rear brake drums and two FOMOCO backing plates.
Drums are Freshly turned at 10.008 and 10.010, so they almost like new.
They have been blasted and painted a cast iron color.
Backing plates are 70859 KH w FOMOC SCRIPT.
I can text or email pictures.
$1500
Bruce 310 594 1969
#14
Services Offered / Classic car storage
February 04, 2019, 11:00:31 PM
I have two open spots at my warehouse near LAX.
$400 month .
Bruce 310 594-1969
#15
SAAC Forum Discussion Area / Re: 6s2372
August 24, 2018, 02:41:06 PM
Thanks. VIN stamp does not correct. .no stars at the front and end also not numbers are not straight