News:

SPECIAL NOTICE - See SAAC-50 Forum for DATE CHANGE for SAAC-50

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - khp352

#1
Thanks for the help. I found that I was being apparently overly cautious and did not have the main fuse block as tight as I should. Put some extra turns on it and it had power. Also once figured out I needed the 4plug that goes back into itself on the firewall I had ignition. Buying one in parts with cobbled back together wiring to go by has been interesting. Again thanks for the help and ideas.
#2
I have power to most of it now. The ground wire that goes to the center stud on the oil gauge where does the mate go. Only 2 studs on the amp gauge.  Thanks for the help. 
#3
According to the Shelby supplement wiring book I have I believe I have everything connected right. I also have the ammeter junction block wires according to cobranda website I believe. I will take pictures of wires I can't find in book. All wiring is new except the plugs going to fog/interior switches. There is a what appears to be a black jumper wire at the gauges, blue/white wire that runs lighter and a female red/blue that comes out of male connection. I am including pictures. Thanks for the help! 
#4
My issue is in the console then. I will trouble shoot there. I contacted the company that sold me the looms and they sent me to the manufacturer. The manufacturer/owner told me "I make the product I'm not a mechanic".  Thanks for the help!
#5
Hi,  I bought a 1969 GT350 in parts. The wiring was cut, spliced and burnt. I bought all new wiring and have power to console through the Shelby wire feed.  On Cobranda website there is an ammeter junction block wiring diagram. I have it wired as shown, but there is a red wire shown that was not in the wiring kit. My question is where do I get the power wire and where does it go as I assume it powers the fuse block which I have no power to.  I can make the power wire if needed.  Any help is appreciated.  Wiring obviously not my thing. Thanks.
#6
1969-1970 Shelby GT350/500 / Re: Wiring for 1969 GT350
December 01, 2018, 01:13:46 PM
Thank You!
#7
1969-1970 Shelby GT350/500 / Wiring for 1969 GT350
December 01, 2018, 07:19:36 AM
Restoring a GT350 and the wiring harness is pretty chopped up.  Looking to replace all of the wiring harnesses.  Looking for a recommendation for a company that has them.  Thank You.