Messages

condition is good  and the date  code 571

Thanks, you are correct, I was mixing up carbs, my bad.

I've recently began cleaning out my storage unit and came across a 65 date coded 715 Holley four barrel carburetor. will try to post pictures. Price $2400.00

Right, sorry. wanted to reach the GT40 gang.

I have a unfired, rebuilt short block, Mexican-capped .030 over, short block for sale, pictures to follow, or will send direct to interested party. also good hipo heads, same early vintage.  $2600.00 short block, $2200.00 heads, OBO, also a fresh, Tranny-Bill built iron T-10, never run of course, with the better input shaft. 2800.00. a McLeod 289 clutch pressure plate, new in the box. make an offer on the above. Private message please. Duncan

interested, where is it located? Shipping estimate? Thanks

I will post pictures soon. they are serviceable heads that are from the estate of a noted cylinder head specialist in the NW. My project is now history and I will not be using them. My understanding is they were for racing only and about one hundred sets were produced...and there are very few survivors. the last and best of the 289 heads. Will be marketing more widely but posting here first, as Real GT40's should have first crack at these C6 casting heads. offers near ten. last ones to sell went for ten...post PM.

Want to buy, 1967 GT500 4 speed. private party. Cash waiting. Buyer has been waiting to reach a point where funds were available and now that point is here. Please respond with a private message. Thanks.

FOR SALE. Kirkham FIA 289 chassis. early 5 bolt hipo 289 drive train components. Aluminum FIA body available. Health issues ...well you get it..$35K with body, $25K without... negotiable. photos to follow.

Heads sold

Block is sold, heads for sale. $1400 plus shipping....

Perhaps remove the bolt, match it to a longer bolt and replace? just sayin'

I need the block in the Seattle area. I have a container I can ship to you empty that will hold it...? Send a picture or two of casting dates, etc.

Seeking a bare 289, standard bore, block. casting date between January and June 1966. Please PM or respond here. Thanks

Crew cut...for sure....he needs a beak....Miles had the beak that's for sure...