Messages

Saw (and heard) the real deal while on the GT350 tour in New Mexico last week. Awesome car.

I only have the Park light. It is the yellow socket with a green and a black wire.

Hi All,
Recently picked up a few carbs. All are untested. All plus shipping.

3255-BE Date code 4B2
Was told these were race prepped from Ford/Holley, mechanical secondaries, no choke
427 Cobra?/ GT40? $1000

3259 reissue, Date code 1192 $1000

8007 looks barely used $250

Thanks for looking,
Tom

Hey all,
Trying to replace the sending unit for my temp gauge. I read the SW 2328 motor craft unit (with the green top)was correct, however, the threaded lug that the wire connects to is smaller than the connector. What it the correct sender?

Thanks,
Tom

Thanks for the great info. I may take you up on your offer. I bought the car in January. It had been sitting since 2010 so it's taken me a while to bring it out of hibernation, (everything leaked). I'm going to enjoy driving it for a while before fixing more stuff.
Happy 4th,
Tom

So after a little more investigating, I found a small jumper wire going to the ignition switch. I checked the vacuum motor with an ohmmeter and the circuit was open when the wheel is in driving position. I'm assuming in that position the circuit should be closed. Is there a way to repair or clean the contacts or does it need to be replaced?

So it looks like I may be missing the small harness. Any idea where to get one?

Everything is connected except the wires for the vacuum motor. It tilts away when the door opens.

Was under the dash yesterday and for the life of me, I couldn't find anything that the motor would plug in to. Would it have been a mini harness that would interrupt the wiring from the ignition switch? Does anyone have a picture? Also, the wheel will tilt away when the engine is running and the door opens. Could that also be because the wiring for the motor is bypassed?

Thanks,
Tom

How can I ID a correct air cleaner and snorkel? Need to find correct one. Is there any interchangeablity? Same for the heat tube.
Thanks

Thanks, guys.
Yes, I noticed the vacuum motor has a plug with wires but couldn't see where it would plug into.

Thanks Jeff. So being able to start the car with the wheel away is normal?

Did the 4 speed cars have a NSS? I'm able to start the car with the steering wheel in the tilt away position.Just curious
Thanks,
Tom

Awesome! Thanks.
Is the wiring the same for the repro gauge as factory? The repro does not use the cup to mount it and the light socket plugs directly into the gauge. The ground wire ( I'm assuming the bottom lug) does not ground to the outer case, so it would need to be grounded to make the light work

Hey All,
I have a repro oil pressure gauge. Can someone chime in on which wires go to which terminals. I've numbered them 1, 2, and 3.
Thanks so much.
Tom