Messages

Sold. Thank you.

This is the shipping case that it came in.

Thank you
Bob B.

Hi. Current photos. Please note the scratches on the case. When it was packed , sheet rock screws were put thru the shipping case that rubbed against the the member.

This is the tag

Hi Guys.

I bought this 3rd member from Jim a few years back for my 65 car, but never installed it. Its a very nice piece.
I will add more pictures of its current condition.  I never even removed it from the shipping container.
Looking for $3800.00 plus shipping
Thank You
Bob B
201-954-6039. or Message me.

Quoted with all due respects.

"65 GT350 3rd member detroit locker 411.    Extremely nice 65 K code 3rd member 28 spline with old school detroit locker.  correct early 65 case and bearing retainer/  ford gears.   restoration includes. hot tank cleaning  of all part.   case has been checked for cracks  glass beaded, red oxide primered.  machined bearing retainer for bolt s.   locker cleaned andchecked.   gear set tumbled to remove any imperfections. steel rebound plate is as good they come and looks like NOS. I have the snubber rubber and will include. driveshaft yoke is the correct Kcode with the long ribbing on the side and the metal is very nice- now oiled to protect   new bearings,  seals  and setup.  I have the original tag off this that will go with it. pics to be added as i get them, doubt you will find a better example."

Thank you.

Bob B.

Thank you.  I tried there, but communications were tough.  Now sold out.

Bob B

Hi guys,  Im looking to purchase a pair of 65 rear axle bump stop relocation brackets.

Thank You

Bob B

Hi Guys.

Im looking for the following.

65 override traction bars.  complete S1MS ends fine thread bolts etc.

Bump Stop relocation brackets with rubber bumper.

10 x 2 1/2 drum brake assemblies complete.

Thank You

Bob B

Please contact thru the messaging system.

Guys, Thank You For the info.  It is appreciated

If someone does see this and has a tank for sale, let me know.

Bob B

Hi Guys, Im looking to purchase or have fabricated a double gas tank with the internal baffles for a 65 66 GT350R.  Any help will be appreciated.
Please contact thru private messaging.

Thank You

Bob B

Hi Guys,  I hope I have this in the correct spot,  Please advise me if not.  I have a listing on EBay for a frame jig that we made to do rust repair on our cars.  Its pretty handy to have when needed.  The price on EBay is $1000.00.  We have updated the eBay listing with a picture of the unit collapsed and its dimensions collapsed for those who have asked.  Included is the link below.

It breaks down into a smaller unit and could possibly be shipped, but would prefer local pickup.

Thank You.


https://www.ebay.com/itm/332554786284?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649