Messages

1960.  I need three sets please.   

cbrownmustangs@hotmail.com if you need any info.

chris

thank you guys for the kind words and support !!  We have some pretty cool new stuff coming as soon as the country gets back to work...

chris

Hmm,, That might be the culprit .  Im going to check that this morning.  I  am hoping someone has switched the metal chassis side mounts which would explain problem.

thank you chris

Hello, I have a 67 gt350 auto paxton equiped  in my shop and  there are cut outs in the hood to clear  the paxton.  Can anyone provide me with the correct part numbers or interchangeable part numbers for the engine rubber mounts and  the frame side mounts?  Are the frame side mounts any different form standard small block 67 ?

chris

thank you for the purchase and compliiment!!

chris

Ring me up or  email me.    cbrownmustangs@hotmail.com

shop 573 754 6940

ok.  thanks as always

chris

What determined if inlet on fuel log was straight or 45 degree?

chris

Here is pic of one of the steel reinforced on an early 67 car.
I also have an all fiberglass hood that has a more pronounced peak all the way up but cant say that it has not been messed with.
chris

Thank you guys!   I ws worried i needed to fix previous body work on a body line that was deleted...

chris

So I have had quite a few 67 Shelby 's in the shop recently and three here now.  I have a variation on the  body line that goes down the center of the hood.  Two pretty original cars here  it seems  the body line fades out before it gets to the front scoop opening approximately 12 inches back.  What is correct for these cars for the body line? continue from back to front or fade out before the hood scoop and then start again at the peak of the hood scoop on the lower part of the hood?

Chris

thank you all very much!!

chris

My friend, Chris Layton has recalled the story to me on when Herbie bought the car out I believe Manhattan. Said he walked in to the dealership and told him he wanted to car. they did not believe him. He left went to the bank got cash came back and paid them!  I have not watched the Jay Leno interview yet. So hopefully I'm not reiterating on what happened with the car. 

Chris

So what about a january  built car?  656 


chris 

Are all rear end caps supposed to have 3  philips head screws in the lower portion attaching to 1/4 panel?   

chris