Messages

Sorry, I think the NOS numbers should be C7OA
C7OZ is the repro number

Looking for NOS C7OZ-3105-B and C7OZ-3105-A
Upper and Lower Ball Joint Boots
Not happy with the Carpenter repros

PM Sent

Are there inside pages also, or just front and back? Thanks!

Thanks for the help. Question answered. I'd be lost without this Forum!

Car was built mid- Jan 1966.
Don't recall any sealant on the plates when I took the car apart. It is an over ride car so the outer plates had been moved inward a bit. Just asking because I've always read the inner plates had been sealed.

Did the seat belt anchor plates under the car have any type of sealant applied to them? Thanks

This may be a silly question, but would a radio delete car still have come with a speaker? I'm guessing not.
Thanks

I have a set from the above mentioned guy from California.
While the texture was very accurate, they were about 3/8 inch short of fitting in my aluminum quarter window frames.
For Sale if anybody wants them.

Had the same exact issue in Dec. of 2018, so you are not the first. Apparently my words fell on deaf ears. Was happy with the fit of the molded part, but the outer edges weren't even close. Lots of trimming involved. How hard can it be to cut a trunk mat to the proper shape?

Narrow range... needs to be 5M to early 6A
But thanks to everyone for offering up what they have!

TLea...pm sent

TLea ... 6A3 would be good. Where are you located?

WTB 289 Block with 5M or early 6A date code.

I warmed our warped ones up then clamped them in between some 1x4's to cool down. Ended up perfectly straight but also shrunk 3/4 inch in length!