Messages

Complete 428 cobra jet smog system.
All original. It has been on a shelf  for 50 years. Even wittek clamps are dates coded.
Pump turn freely and fittings that screw in the heads are free too
Pulley is none AC

Diverter valve: april 4 68
Pump :  10 sept 68

Ask for more pics as I can not upload more in 1 topic

Asking 3500 $US

I can bring it at Ford show in Carlisle,PA this summer in june  for free.
Just need a deposit as I live in Canada and I dont want to have to bring it back. Other than that I can ship anywhere.

PM for more

Patrick
Québec
Canada

Im chasing an electrical issue here tonight on a 69 GT500 I am finishing.  Everything runs and drives and works perfect....except the fog lights. 

Inside the car the interior light switch works with no problem in the console.  But when turning on the fog light switch it just clicks the relay on and off every 5 seconds and the fog lights never turn on.  I  have a complete extra gauge and switch console that I swapped out and does the exact same thing.

So I think something isnt wired here correctly.  Can someone confirm the routing of the three wires here at the voltage regulator, starter solenoid, junction block? 
First picture below is just a reference photo I pulled from Bring a Trailer (Nate Jones) Shelby that recently sold.

2025-02-20_21-11-19 by Marcus Anghel, on Flickr

20250220_222819 by Marcus Anghel, on Flickr



   

Hi.under the console, it is not a relay. It is a 30 amp thermal breaker which  will pop out and on automaticaly. it will sound like a relay if you got overloaded. I would check the load with an ampmeter beside the breaker first.

Patrick

Hi, just get the authorisation from Bob Gaine to share this installation sheet I've uploaded from the rip forum many year ago.
I've used this to install mine in my S9...
From all the bracket installation pattern I've seen, this one is at least documented.
I suspected no installation document was available and part of the antenna kit in the trunk at dealer when they installed them other wise they would have respected that.

Patrick
Canada

 

 

West coast classic cougar offer staples kit for the beltline pieces. Is it what you are looking about ?

Patrick

Here a NOS black glued with part number you can barely see.

Patrick

I am still looking. I would consider a NOS skin at this point

Patrick

Hi all. I am looking for a good original driver door for 67/68.

I am in Canada but I have several contacts/adresses in USA if needed.
Join together at Ford Carlisle 2025 could also be an option if shipping is an issue.

TKS
Patrick

Looking for only one "428 cobrajet' fender emblem for 69/70 New or in perfect condition. (found)

TKS
Patrick, Canada

Ok tks for reply...

Patrick

Hey Jason. I didnt know you were the hood guys's story when we get together last month!!!! My hood part number is gone on mine. let me know if the one in your old hood frame is savable.

Patrick
Canada

T-Bird 67 air cleaner same as S9 500. Nice piece with surface rust. You need to take the baffle off.
400 bucks.


I will be at Carlisle Ford show next weekend. So I can bring it there for free.

Patrick

Sold

Very good 1UA crank. It is ,030 rod ,030 main and dont need to be recut. Engine has run low mileage before being disassembly.  it has been balanced to different rods weight than leman. So it would need to be rebalanced to original if you want to used leman rods.

I will be at Carlisle Ford show next weekend so I can bring it there for free.

Asking 400 bucks

Patrick

Remove the ashtray, remove the 2 screws  and pull the top part rearward as there are fragile clips at front.

Patrick

Top of console only and it clear.

Patrick