Messages

All;
Has anyone dyed a Motorcraft paper air cleaner element the manila color to match a  1967 GT500?
Any and all help will be greatly appreciated.
Can't afford the $1200.00 for a real one.
Thanks in advance to all who respond.
JoeS

Wanted to Buy;
Used 1968 Shelby GT500 ai cleaner base.
Email Joe at joesen@aol.com
Thanks

Thanks very much for your help

Looking to buy a copy of July 1995 Mustang Monthly magazine

Looking for a dealer license plate frame, trunk mounted decal or metal badge or any dealership advertising from Robert J. Poeschel Ford in Oxnard, CA

Yes sir, I have a gasket between the head and exhaust manifold.
Also, I will check about L & R plates that fasten to block
What would be the average normal clearance between manifold and frame?
Thank you so much for your help

To All;
Any info or advice would be greatly appreciated.
I have installed a 1968 428 engine with C80E heads , a Edelbrock 4 BBL intake and repo Cobra Jet exhaust manifolds from NPD in a 1968 Mustang convertible.
The right exhaust manifold touches the top of the frame.
Car has not been wrecked and I believe I have the correct motor mounts.
What is the standard clearance and can you advise me as to what I am doing wrong?
Thank you in advance for any help.
regards
JES

RADIO CONTROLLED MODEL AIRPLANE HOBBY SHOPS HAVE THE CORRECT GAUGE WIRES
IN 36 INCH LENGTHS,