News:

SPECIAL NOTICE - See SAAC-50 Forum for DATE CHANGE for SAAC-50

Main Menu

Cobra intake

Started by SCOTTGTK, October 19, 2024, 03:35:35 PM

Previous topic - Next topic

JD

Was trying to help show what you have, since posting was not easy.  There are many variations of small block intakes which makes it difficult to know just what someone has in terms of "correctness" and/or value.

There are others on this forum that know a lot more about these variations than I do.

I was trying to gather images of these variations and got as far as this, see attached, and was told there were many more out there and I stopped.
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0

Coralsnake

Starting to look like the ten spoke wheel chart 😉
The original Influencer, check out www.thecoralsnake.com

Bob Gaines

#18
Yes there are others not pictured. SCOTTGTK needs to send a over head picture of his like what JD posted to Coralsnake to post.  Preferably a picture without the carburetor or gasket underneath  on it.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Coralsnake

Please send me pictures

Dont give up JD keep looking for them you are the best resource
The original Influencer, check out www.thecoralsnake.com

SCOTTGTK

Thank you all... I'll do my best to get some over head shots as soon as I can. I cannot get with carb off as I'm running it.
Thanks for posting Coralsnake.... I'll continue to try and upload from my end as well.

Coralsnake

The original Influencer, check out www.thecoralsnake.com

SCOTTGTK

I should be able to get a pic or more to you today Coralsnake and I'm gonna attempt to post again from my end.

Coralsnake

The original Influencer, check out www.thecoralsnake.com

SCOTTGTK

Just emailed to you CS... I'll now try to load from my end as well...

SCOTTGTK

All following/contributing to this thread, thank you and be aware, these pics are not the best... best I could get at the moment.. if you "expand" on them you'll be able to see what I see... I understand looking underneath would be helpful as well, but I wont be pulling the motor for a few more months for sure... Thanks again for your thoughts!

SCOTTGTK

HHere are 4 of 5 pics... I think... it stopped me at 4...I'll try the 5th on another post..

SCOTTGTK


Coralsnake

#28
I need to make them smaller, I will load them shortly
The original Influencer, check out www.thecoralsnake.com

SCOTTGTK

I just tried to open one of the pics and on my end it just sends it to downloads... Don't know of that will happen to all