67 GT500 Distributor Primary wire

[shelbydoug]

What primary wire should be in the 67 GT500 distributor? Is it a molded 90 degree end with AUTOLITE in it and a specific color?

[rockhouse66]

I think you want the wire with the eyelet and yellow molded connector.

[Special Ed]

The whiteish colored angle boot (c7vy) has autolite marked on the black rubber coming out of dist housing and is for single points 390 428 correct for 68 69 gt500.

[Bob Gaines]

What primary wire should be in the 67 GT500 distributor? Is it a molded 90 degree end with AUTOLITE in it and a specific color?

The primary wire on the 67 GT500 distributor has the black plastic molded end eyelet.

[rockhouse66]

LOL!  How may answers did you want?  Bob is probably correct for a '67, though I have been using the yellow ended ones on the C5 distributors I have done.  So the black one is same as Hi Po 289?

[Bob Gaines]

LOL!  How may answers did you want?  Bob is probably correct for a '67, though I have been using the yellow ended ones on the C5 distributors I have done.  So the black one is same as Hi Po 289?

The black one is also the correct one to be used on the 289 hipo . The yellow ended one is the service replacement for the mechanical advance duel points. There are repros of the black one.

[shelbydoug]

Thanks to all. I don't remember this subject coming up before. It would help if the search function was better.

[430dragpack]

I asked about this a few months back in the concours section of the forum.  It comes up in a search for the whole SAAC site, but won't come up in just the 67 Shelby section.