1966 S2MS COBRA GT350 Intake "B" - SOLD

[Snydly289]

I collaged photos together so that the thread remains reasonably organized, not flooded with a ton of photos (I am aware though I have a lot of photos posted already).
I have created 3 separate listings/posts for the 3 intakes labeled and pics annotated "A", "B", and "C".

Would definitely be willing to meet semi locally to the Seattle area (Bellingham and Portland Oregon are about as far as I would like to travel).

Intake "B" – Front runner firing order, angled A, OECO Stamp.

Intake has heli-coils installed on the 2 thermostat housing bolts, as well as all 4 carb stud mounts. All other threads are good.

Intake also shows corrosion over time, especially around the water jackets. I used a metal pick to point to where the corrosion was the deepest on the rear surface. The intake was also coated (done by the previous owner ) with an automotive clear coat, so I lightly fine glass beaded the clear off. Other than the clear coat and the heli-coils, no modifications have been made.

Same as Intake "A", the A in the COBRA plate is very slightly clipped / angled, if someone more knowledgeable could confirm that this intake is a clipped / angled A intake, I would greatly appreciate it. Clipped / angled A intake.

Asking $1,100 $950 $730 plus shipping due to heli-coils and corrosion.

[Snydly289]

More Photos

[Snydly289]

Price reduced

[Snydly289]

Price Reduced to $730

[Snydly289]

Intake has been sold