Hawk Pad thickness. Others have issues?

[1967 eight barrel]

I went to install Hawk pads and could not get the pad in the front side of the caliper. If so, is there a safe way to remove a 32" of an inch or so? I did notice there was an noise insulator on them.

                                                                                         -Keith

[Bossbill]

I would take a flat plate (steel, marble or glass), lay down some 100 grit and sand away the difference on the friction surface. You are '"surface plating" the pads. Use a caliper to measure thickness as you go.

I've had issues with race pads and that was my cure.

[1967 eight barrel]

Bill,
I had considered a flat surface of that nature, but was concerned about seating correctly. I feel comfortable about using the method now. Thanks, Bill.
                                                        -Keith