GT500 1967 Exhaust Hangers and Motor Mounts for concours/ Survivour

[Kent]

Hello where do I find good repros of the GT500 exhaust hangers and Motor Mounts? Bob what are you using?

[Coralsnake]

The brackets can be sourced used, the insulators are around in nos. There is only one source for exhaust brackets in my opinion, unless you want true nos, thats Scott Fuller Reproductions.


For a survivor, you will want to souce original parts

[Special Ed]

Are u wanting engine block frame brackets or the plates on the block?

[Bob Gaines]

The brackets can be sourced used, the insulators are around in nos. There is only one source for exhaust brackets in my opinion, unless you want true nos, thats Scott Fuller Reproductions.


For a survivor, you will want to souce original parts

What he said +1

[Kent]

I´m looking for the engine rubber motor mounts. I bought a set "concours" for a mustang but they look like crap, holes wrong, rubber finish wrong, no part number.

[Bob Gaines]

FYI the originals did not have engineering numbers stamped into them anywhere and typically only one side had a Ford trademark. This is in reference to the exhaust hangers.

[Special Ed]

All the big block rubber mounts I got have ford eng# in the rubber and I got some c7za # mounts and I think fastback was an H or was that 68  but I know c7za-k is convertible big block.

[Coralsnake]

The 1968 insulators have engineering numbers molded on them. The ones you are most likely to see now are the D1ZZ service parts

[Special Ed]

Just pulled a set of c7za-6038-d  FOMOCO  AU   marked   engine rubber mounts out of my motor mounts shelf inventory along with a set of c7za-k rubber mounts.

[Kent]

So there are no correct reproductions of the c7za rubber mounts?

[Bob Gaines]

So there are no correct reproductions of the c7za rubber mounts?

No correct repros of the rubber motor mounts. Nice used originals in good shape are still a viable source for the time being.