Wiper switch wiring disconnect help

[6s1640]

Hi All,

I need to replace the wiper switch, but am having difficulty disconnecting the wiring harness.  I can't seam to find any levers to pinch to release the grip.  Any suggestions? 

I swear I have done in the past, but can't figure it out this time.  Coming back from a Show and Shine I went through a cloud burst with no wipers.  Good thing I was going fast enough, most the water was running off the windshield.

Thanks

Cory

[GT350Lad]

"Good thing I was going fast enough" love it Cory. No wipers needed mate

[TLea]

Cory.  I can check when I get into the shop tomorrow but I'm pretty sure it just plugs into the back of the switch with no release tabs

[mygt350]

Cory, it just slips on the rear of the housing. No tongs or clips.

[jamesfee]

Cory, I believe the guys are correct that the plug just pushes on (but can be damned ornery from corrosion).
As a sidenote, I have found that Rain-X offers significant help without relying on speed in a downpour. The original wipers are modest at best in making the water go away. I have found that a good cleaning and a coat of Rain-X helps visibility in unexpected bad weather when driving.

j

[papa scoops]

Cory, I find that on later model cars that have the tong and clips on 'em, you just bust 'em off and reattach with superglue. works good. phred

[6s1640]

Hi All,

Thank you for the tips.  I will try her again.  The Rain-X is a good plan B.

Cory