68 AC and PS install to block - spacer?

[Milo]

During my mockup, I noticed noticed a gap where the AC bracket that holds the pulley meets the PS bracket at the block. Small gap, more like a thick washer. Is that true? I didn't exactly tighten every bolt up, as it was just a mock run, but it gave me pause.

Dropped the engine in yesterday! Looking forward to being on the other side of that mountain.

Thanks again, Chris!

[CharlesTurner]

Small block/big block?

[Milo]

Sorry!

68 GT500 428PI

[Bob Gaines]

 Compressor bracket leg connects to same bolt as upper PS bracket bolt hole.

[Milo]

Yes, but just to confirm - there is no spacer that goes between the block and the upper PS bracket? Outside in is AC compressor bracket leg -> upper PS bracket -> block, correct?

Thanks!

[Bob Gaines]

Yes, but just to confirm - there is no spacer that goes between the block and the upper PS bracket? Outside in is AC compressor bracket leg -> upper PS bracket -> block, correct?

Thanks!

No spacer there. Just the compressor bracket leg and the PS bracket .

[shelbydoug]

The spacer is used if you DON'T have a/c.