Hipo motor mounts

[6s855]

Just put the rebuilt engine and trans back in 6s855 and am puzzled to see that they seem set too far forward.  I believe I may have
mis-assembled the mounts by swapping the top brackets that bolt to the block (C30Z-6068-C) to the wrong sides.  This bracket has a "bulge" that is not centered but offset more to one side.  I've stolen the only picture I could find from Virginia Mustang that seems to show the "bulge" offset to the front.  Mine are offset to the rear.  So before I start jacking to remove my mounts for a redo, I'm hoping for confirmation of my screw-up.

[CSX4781]

Hey Jay, I sent you an email.  Give me a call, I'll be up for a while

Dave

[texas swede]

Do you have the original mounts? 6S923 was produced at San Jose 1/12/66 and has the standard mounts and not the HiPo ones.
Texas Swede

[6s855]

Early ones were on the car when I got it.  I know now they're the wrong ones.  Have to get the mounts common to all 289's after 11/65.  I'll just add these mounts to my ever-growing extra parts pile.  They may even be original hipo's.  Guess I'll post for mounts on WTB or get good repros if they exist.