What did you do to your '67 today?

[csheff]

Just paid a bill for some work done on mine. lol

[Shelby4Life]

This arrived, so I'm a step closer. 

[jguyer]

Just paid a bill for some work done on mine. lol

What did you break now?

[557]

Well,yesterday,I drove it in fairly heavy rain for the first time in years.God that was an unpleasant experience.Thing wanted to lose traction every time I released the clutch.Not fun......

[rmarble57]

Drove it.

Decided to diagnose the seat belt light.

Discovered a defective part.

Ordered replacement part.

[67411F--0100-ENG.]

Hello Everyone,

I went over to the Shelby American Collection in Boulder and started 0100 up to circulate the fluids for a couple of minutes.  It is always nice to go over there and see the amazing collection of cars.

Thanks,
Eric

[rbarkley]

Hit the back roads to see how the car was running.  Evidently, pretty good!

[Lfino]

I spent enough time to kill three rechargeable batteries on my Makita cordless drill with a brass wire brush on it, cleaning surface rust off cast iron parts for refinishing.  Bellhousing, strut rods, spindles, coil springs, motor mounts, steering shaft, clutch fork.  Fun times in the 40 degree shop.

Kinda like this!?

[oldcanuck]

It was 60 glorious degrees in E TN today !  Not the typical Feb. winter day for sure.

Roads were dry....... Yup, you guessed it, burned up about an eighth of a tank !

[T-Bone68]

Dip coated the pedals yesterday as part of refurbishing and installing a correct/original 67 pedal set.  Video came out nice.

https://www.youtube.com/watch?v=W35EYNtImjI 

[oldcanuck]

First bath of the year !  66 glorious degrees in E TN...... 2 applications of C2 Crystal ceramic coating..... tomorrow, we ride !

[Bossbill]

Since I'm replating/restoring every original nut and bolt, where possible, on my car I could post every day. Recently, I've had great success with the Caswell Plating system.

[2112]

Since I'm replating/restoring every original nut and bolt, where possible, on my car I could post every day. Recently, I've had great success with the Caswell Plating system.

Boy, if you have not already, a thread on your Caswell plating system would be fantastic.

I had asked about the Eastwood system a few months back and didn't get much information.

[shelbyhertz66]

Just drove it  for the first time since installing my rebuilt Hipo
a few laps around the neighborhood ,seems great. Now just need to find
out the best GL4 gear oil to change in the 4 speed trans.

[jguyer]

Found the LH air vent. Control cable broken, may be able to fix it. But will probably buy new cable with metal, rather than plastic sleeve.