console arm rest advice

[Supersnakeingrass]

Mine looks like the one shown in KDunne's post. The point on mine has a slightly smaller radius, but is not a sharp point. I'm not the original owner, yet I believe the stud in my car is original.

Steve

Although I have sold my car.  I remember that the one that I had was the same as KDunne's post as well. I was not the original
owner but the console pad and outside components were for sure original .

SSIG.

[nvr-enuf]

This is my tray after flocked

[QuickSilverShelby]

Holy flock, that is beautiful.

QSS

[nvr-enuf]

Thanks - my tray was really beat up. Large holes which held the screws, missing driver front top side extension, hole in rear by where the hinge is located

I purchased a supplier repo part, figured "it is much better looking than my original"

A forum expert said "fix the original"

Gorilla epoxy, fiberglass matting, body fill putty and with time the old tray looks pretty good for a newbie. 

BUT that repo tray came in handy for the repairs since it has grain, not exactly as original but better than no grain. 

If any one needs pieces to fix theirs, send me message. You can have free just pay for the ride

And thanks to the expert that steered me in the right decision

The original trays are much more rigid than the repos

[TLea]

Here's a pic of the stud that came out of mine - again, I don't know for sure if it is original

Not