Carb spacer installation

[Bill]

Starting my carb reinstallation, have the Felpro installed above and below the spacer now and have a wonderful vacuum leak (high pitched whine). Thinking my custom cut MrGasket picture below might alleviate the vacuum leak. All to be installed dry I assume as that is what I am used to. Or is there a proper part number I have yet to stumble across that will work without custom cutting?

[mr68shelby]

Check the spacer. The reproduction for my 68 was not flat. I used a large flat file to get it flat. Mike

[TOBKOB]

Sand paper on a pane of glass is also a good way to get flat surfaces. 

TOB

[Bill]

Check the spacer. The reproduction for my 68 was not flat. I used a large flat file to get it flat. Mike

Sand paper on a pane of glass is also a good way to get flat surfaces. 

TOB

Checked on a the glass table in the house, SWMBO was not amused 

[TOBKOB]

You have to wait until She leaves the house...

TOB

[Bill]

You have to wait until She leaves the house...

TOB

Sure, now you tell me 

[Special Ed]

U need 2 black top photo gaskets  not the mr gaskets type

[Bill]

U need 2 black top photo gaskets  not the mr gaskets type

Two on the bottom and one on the top of the spacer between the spacer and the carb?
Or like I have now, one at the bottom between the spacer and the intake, and one between the spacer and the carb?

Thanks in advance,

Bill

[Special Ed]

1 black type on both sides of spacer

[Bill]

1 black type on both sides of spacer

Thanks