Holley atmospheric Vent "button"

[hurlbird]

The little vent on the front bowl that is covered by the "button/cap" on the arm seems to be missing the rubber sealer. Can i just glue another on the button or can i buy a new button with the rubber on it? i dont find anything on line. Thanks

[Mike Laucks]

Hello, I had my original GT350 4 sp  CARB rebuilt by Steve Carburetor in NJ he did a great job & he replaced the breather , he may have some for sale office # 201-935-3499
here is pic, if this isnt what you were looking for sorry about that.

good luck

Mike

[hurlbird]

thank you

[98SVT - was 06GT]

That part comes in most Holley rebuild kits. Or check Holley's web site and see if they have them separately. Yours sounds like the ones with a different arm with a steel washer and no rubber.

[Bob Gaines]

The ones in the Holley kits will work but are different then the assemblyline vent caps. I posted a picture of a what a assemblyline version looks like.

[gt350hr]

     I bought a package of ten exact reproductions off of epay. I don't have a link as it was months ago when I bought them. The orange parts in kits are for accelerator pump "one way valves" on specific float bowls.

[Drew Pojedinec]

     I bought a package of ten exact reproductions off of epay. I don't have a link as it was months ago when I bought them. The orange parts in kits are for accelerator pump "one way valves" on specific float bowls.

Mile Bolduc sells them on ebay. I buy a handful every once in awhile.