One piece fuel line, GT500

[nwfire]

Can anyone recommend a one piece fuel line for the 67 GT500 that actually fits without making a bunch of changes to it?  Purchased one from NPD and although it says it's for the GT500, it's quite different than the one I have on it now.  Also, any easy way to thread one of these in place??

Thanks.

[tonys_shelby]

Just to make sure, you know the one piece goes down the driveshaft tunnel right.

[nwfire]

Yes I do.

[JD]

When I did it the car was a bare shell (no parts on it) on tall jack stands after painting, it was not tough.

Is your car complete, rear suspension and drive shaft in it?

[nwfire]

Yes, drive line, rear suspension, exhaust system is all in place.

[tonys_shelby]

Mine also was bare shell after painting and I didn't think was hard. Only part was the bend into the engine bay around the frame had to be manipulated a little.

[JD]

Yes, drive line, rear suspension, exhaust system is all in place.

try removing and or dropping some of the rear components/assemblies until you can sneak it in.

[vtgt500]

The Classic Tube stainless fuel line I installed fit fine.