67’ Power Steering Control Valve #16 Clamp

[rcgt350]

I have a couple versions of the Witteck #16 worm gear clamp to install around the P/S control valve/hoses, can someone comment on which style might be the one or close to what was used?

[Bob Gaines]

Of the two posted the one on the right is closer to what would be seen on a later car. Earlier cars used a special crimp type clamp. When you car built at Ford or what Shelby VIN ?

[JD]

His car is early, 

Bob, Is this the type clamp you are referring to?  (your image)

[Bob Gaines]

His car is early, 

Bob, Is this the type clamp you are referring to?  (your image)

Yes JD that is the early style.

[rcgt350]

Ok, where does one find that?

[JD]

Not aware of any reproduction available, thought that was a matter of finding good used.  Hopefully I'm wrong (again).

[Bob Gaines]

Ok, where does one find that?

I know a guy   

[roddster]

  I can tell you that on an original one there is a stamp on it shaped like a keystone.  I found one in a junk yard on a scrapped 67 Mustang 6 cylinder a long time ago.  The strap has long since cracked.   This is something I hope Mr. Fuller will get around to reproducing.