1967/68 big block fe engine mounting plates.

[V8Dave]

Hello everyone.
I am currently looking for a pair of original 67/68 gt390/gt500 big block ford fe engine mounting plates. The plates that bolt to either side of the engine block which then allows the engine to attach to the rubber/metal engine mounts. I believe the factory part number is c7zz-6046 if I'm correct.
I'm not sure if there is a difference between 67/68 big blocks as regards the engine mounting plates or if they are the same? The ones Im after will be going On a 67 big block if that helps.
If any body has a set(pair) or can help me please send me a email.
Many thanks
Dave.

[Bob Gaines]

Hello everyone.
I am currently looking for a pair of original 67/68 gt390/gt500 big block ford fe engine mounting plates. The plates that bolt to either side of the engine block which then allows the engine to attach to the rubber/metal engine mounts. I believe the factory part number is c7zz-6046 if I'm correct.
I'm not sure if there is a difference between 67/68 big blocks as regards the engine mounting plates or if they are the same? The ones Im after will be going On a 67 big block if that helps.
If any body has a set(pair) or can help me please send me a email.
Many thanks
Dave.

67-70 are the same. The repros are very accurate. It is  rare that you find any used that are show quality after over 50 years exposed to the elements.

[V8Dave]

Thanks for the information and help Mr Gaines. Now I know 67-70 are the same and If the reproductions are very accurate I will be happy to purchase a set from someone on the forum who maybe has them.
Many thanks again for the help.

[Bob Gaines]

Thanks for the information and help Mr Gaines. Now I know 67-70 are the same and If the reproductions are very accurate I will be happy to purchase a set from someone on the forum who maybe has them.
Many thanks again for the help.

NPD sells them but they show out of stock .Mansfield Mustang is a reliable and well thought of vendor specializing in fe bigblocks who may have the engine motor mount plates .  http://mansfieldmustang.com/EngineMechanicalp2.html

[V8Dave]

Hello Mr Gaines.
Thank you for the help and guidance. I contacted bill at Mansfield mustang however unfortunately none in stock. Hopefully maybe a fellow forum member may have a set.
Many thanks again Mr Gaines.

[Bob Gaines]

Hello Mr Gaines.
Thank you for the help and guidance. I contacted bill at Mansfield mustang however unfortunately none in stock. Hopefully maybe a fellow forum member may have a set.
Many thanks again Mr Gaines.

I hope a forum member steps up with a extra set to sell but you may want to check with others larger Mustang vendors . I think Perogie enterprises is the source or at least they used to be when the plates were first reproed .  http://www.perogie.com/

[V8Dave]

Appreciate the the guidance and help mr Gaines and thank you for the information.

[Royce Peterson]

I ordered a set of those block plates from Perogie. They were drop shipped from Crites.

https://critesperformanceparts.com/page8