Which is the correct Assembly Line Water Pump Heater Hose Fitting for 67 GT500 ?

[Kyle]

Hi all,

I am seeing two types of fitting's which is the correct Assembly Line please?

Here two pictures:

Thanks Kyle.

[Kyle]

Any information please?

[Special Ed]

 top shorter looks correct to me.

[Kyle]

Thanks. There were from factory with long fitting's please?

[430dragpack]

Off of #591.

[Kyle]

Thanks a lot "430dragpack"

[Royce Peterson]

top shorter looks correct to me.

+1

[Kyle]

Thanks Royce Peterson.

[csheff]

Isn't the top pic Kyle posted a 68 CJ one?
top pic here is correct for 67? All sources show top pic for a 67 GT-500?
Thanks

Was sealant used on the threads? Or what was?

[Bob Gaines]

Isn't the top pic Kyle posted a 68 CJ one?
top pic here is correct for 67? All sources show top pic for a 67 GT-500?
Thanks

Was sealant used on the threads? Or what was?

Top picture and one posted in reply#4 are the correct ones. Sometimes I could still see a sealant on the threads of survivor fittings. The Indian head shellac type sealant is what looks to be used. At least it gives the same appearance if not the same product.

[csheff]

Thanks Bob
So there were two types used?

[Kyle]

I am looking for one like the picture in reply #4 in good condition or NOS.
If anyone have one please PM sent or Email me kylezammit123@gmail.com

Thanks Kyle.

[Bob Gaines]

Thanks Bob
So there were two types used?

You have typical and not typical .The longer one is not typical however I have seen them used.