R Servo for C6

[aj]

Would an R servo with engineering number of C80P-7D027 be incorrect for a Mustang by virtue of the "P" in the number?   

My understanding is P indicates Fairlane.

Or have there been C8OP servo covers found on original C6 from 69-70 gt500?

[Bob Gaines]

Would an R servo with engineering number of C80P-7D027 be incorrect for a Mustang by virtue of the "P" in the number?   

My understanding is P indicates Fairlane.

Or have there been C8OP servo covers found on original C6 from 69-70 gt500?

C8OP servo cover is typical for 69/70 GT 500.

[Bob Gaines]

Would an R servo with engineering number of C80P-7D027 be incorrect for a Mustang by virtue of the "P" in the number?   

My understanding is P indicates Fairlane.

Or have there been C8OP servo covers found on original C6 from 69-70 gt500?

C8OP servo cover is typical for 69/70 GT 500.

FYI the difference is in the shifter lever .One style is for floor shift and the other for column shift. There is a reproduction floor shift lever that is spot on to convert the column shift to floor shift. 

[silverton_ford]

The O indicates Fairlane, not the P.    Fairlane was a baseline car, so that part is numbered with a Fairlane, but will fit Mustang as well like Bob mentioned.   If it was a Z, then it would only fit Mustang and nothing else.

P indicates automatic transmission.

Here is a good reference on Ford part numbers and how to decipher them.  http://www.fordification.com/tech/partnumbers_overview.htm

[aj]

 Would a C8OP cover be an acceptable part for a VIN-matching tranny in 69/70 gt500?  Or would I be advised to continue the search in hopes of finding a C8ZP R cover(if there's such a thing). 

[Bob Gaines]

Would a C8OP cover be an acceptable part for a VIN-matching tranny in 69/70 gt500?  Or would I be advised to continue the search in hopes of finding a C8ZP R cover(if there's such a thing).

Re read reply#1 . Typical means typical. Something else (C8ZP ) would not be typical.

[gt350hr]

Would a C8OP cover be an acceptable part for a VIN-matching tranny in 69/70 gt500?  Or would I be advised to continue the search in hopes of finding a C8ZP R cover(if there's such a thing).

    You can't search for something that was NEVER MADE. Casting numbers are assigned based on the original intent of the part. For another example your intake manifold says C8OE-C. Same for your cylinder heads C8OE-N. Many component parts were combined to make a specific assembly. IF a part was designed for and unique to a particular model  it would have that model line as the third character.
    The R servo with the C8OP casting number is correct for your car and you should also have the C8OP cast iron tail shaft housing. Those are the only two visual clues ( besides the metal ID tag) that could be scrutinized by ANY judge.
     My use of caps is not internet yelling , it's highlighting important words. No anger here , just help.
    Randy