1968 Convertible - Detailing The Trunk

[gt350shelb]

gt350shelb,

If you are talking about the side reflector screw caps and you find more that 4 for Steve I could use 4 of those myself.

Corey

I will look over the weekend  if you want originals

[Corey Bowcutt]

Thank you.  I always prefer originals.

[CharlesTurner]

Charles

Do you have any picture that show what you describe above with the screw?

I looked and couldn't find any pics.  Had a '68 metuchen convertible that I worked on a few years ago that had not been restored and had that type of setup.

[J_Speegle]

I looked and couldn't find any pics.  Had a '68 metuchen convertible that I worked on a few years ago that had not been restored and had that type of setup.

Not sure which red convertible you were referring to in the prior post (there were two in the post I posted)

Didn't have a picture of the mat, board and screw but had one of the screw where the mat was likely torn out and the board broken away that might help a little 

[CharlesTurner]

This one...  these are pics I provided from a car at the MCA national in Va Beach in the late 90's.

[J_Speegle]

This one...  these are pics I provided from a car at the MCA national in Va Beach in the late 90's.

Thanks - that is the same car as the last two in my first picture post. Just wanted to cross reference for the viewers

[CharlesTurner]

Thanks - that is the same car as the last two in my first picture post. Just wanted to cross reference for the viewers

No worries.  It's a good reference car, but things here and there don't add up, so suspect it had been 'played' with a bit.  Had to correct some items that were copied from that car on the '68 I have now.