68 GT500 tilt away option

[ridgeter]

Early Dec 67 car. I cannot start car unless I gently fiddle plastic pin for cable that goes to vacuum motor that actuates tilt away option.

It was working fine until car sat for awhile due to weather.

My question - is there a way to permanently fix this? Cable adjustment? All original tilt way components seem intact.

Was trying to add a pic?

[Coralsnake]

If you can correct by moving the plunger on the vacuum motor, then it is a cable adjustment.

The can be very touchy.  The movements are literally 1/16 inch

[Corey Bowcutt]

I will tell you mine works great in warm or hot weather. When it gets cold I have to hold the steering wheel down for several seconds even oscillating it a bit until it moves enough to start the car.  I always think I need to lubricate something but just never get around to doing it.
Corey

[ridgeter]

Thanks for sharing. Good tips.

[Royce Peterson]

The cable needs to be tighter to allow the car to start. The adjustment needs to be just right - as tight as possible is normally the way that works.