67/68 GT500 Original AC Oil Cooler, Adapter & fittings

[68stangcjfb]

Parts came out of a 68. Original paint on cooler. Fins very straight. Absolutely does not leak. Setup was on a running engine 3 months ago. I have lines I will include but they are not correct. $1400.00

[68stangcjfb]

.

[67GT500#1594]

Can you post a pic with the legnth of the oil cooler please? Thickness as well.  I need to see if this fits my application better than what I had collected. Thanks!!

[68stangcjfb]

The dimensions minus the fittings are 15" long, 3" thick & 4" wide. 6" wide when you include the hanger brackets.

[Bob Gaines]

Can you post a pic with the legnth of the oil cooler please? Thickness as well. I need to see if this fits my application better than what I had collected. Thanks!!

From a function stand point you can do better. From a originality stand point you can not. FYI the 67 cooler although the same were painted black instead of the teal blue.

[shelbydoug]

Can you post a pic with the legnth of the oil cooler please? Thickness as well. I need to see if this fits my application better than what I had collected. Thanks!!

From a function stand point you can do better. From a originality stand point you can not. FYI the 67 cooler although the same were painted black instead of the teal blue.

Well heck, if you put in an all aluminum 500 cube big block, it's going to melt anyway.

[68stangcjfb]

Bump.

[Mike James]

Anyone have a pic of how the lines go through the radiator support?  Were holes drilled for the lines?

[68stangcjfb]

Bump.

[Coralsnake]

[Coralsnake]

[shelbydoug]

That's a heck of a grommet.

[Bob Gaines]

That's a heck of a grommet.

It is not a grommet but a section of windlace.

[shelbydoug]

That's a heck of a grommet.

It is not a grommet but a section of windlace.

Yes, I realized that right off. I was being creatively critical.

Now that couldn't have been Ford installed so it must have a Shelby part number on it? (there I go being creatively critical again) 

[Coralsnake]

Its Ford