Rear quarter Window Interior Trim

[plowhorse]

I have a set from the above mentioned guy from California.
While the texture was very accurate, they were about 3/8 inch short of fitting in my aluminum quarter window frames.
For Sale if anybody wants them.

[kingchief]

I am interested in a set also. Please keep us posted.

Happy Holidays!

Steve

[Steve McDonald Formally known as Mcdonas]

Count me in as well to this "crowd funding"

[bluemax]

I would be interested as well.

[SFM6S]

I would buy a set and prepay as well.

Joe

[Doug C]

I would be interested as well.

[Chad]

I will keep you guys posted.  It is going to be a three month process.  So that is what the maker is telling me so that means 4 months.
Chad

[Cjc6566]

I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James

[Doug C]

I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James

I would also assist with some dollars if needed.  Doug C

[Doug C]

I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James

I would also assist with some dollars if needed.  Doug C

[s2ms]

These things must have started warping almost immediately. I have a photo of my 66 interior taken in 1973 by a friend of the owner at the time showing the trim , looks exactly the same as it does today....wavy.

[Bob Gaines]

These things must have started warping almost immediately. I have a photo of my 66 interior taken in 1973 by a friend of the owner at the time showing the trim , looks exactly the same as it does today....wavy.

It probably didn't take too many heat cycles for the plastic to start warping.Of course some are worse then others.

[commok]

I'm definitely in, and $200 would seem to be an entirely appropriate price for quality set of 4....

[C Griffith]

I'd be willing to buy a LH&RH set if they look original and fit.
Saves me from making them in my shop. The best of luck to ya.

[Chad]

Guys thank you for all the offers in helping to pay for the tooling. At this time I have it covered.  The tooling cost will dictate what the price of the pieces are.

Thanks
Chad