69-70 GT350/500 help needed

[kasearch@ix.netcom.com]

If you own a 69-70 GT, could someone please check your car and provide me the dimension (as shown in the attachment) of the driver side hood pin bracket. I need the measurement from the mounting side of the bracket to the center of the latch opening.  If all else fails, fabricate.  Wish me luck.

[Coralsnake]

2.75 inches

[kasearch@ix.netcom.com]

I do appreciate the offer.  Branda, along with EVERYONE else, no longer has them. The manufacturer died and no one is reproducing them.  I have one side coming and was going to fab up the other side.  I just want to make sure of the dimensions before I make it.  I may take you up on your offer, but right now, what I am looking for is the dimensions for the driver side, just in case it is different than the passenger side.  Better to be safe than not have it fit properly

[Coralsnake]

Brackets are symetrical

[Bob Gaines]

Brackets are symetrical

+1 . With one side you will have the dimensions to make the other side. 

[kasearch@ix.netcom.com]

Thanks Bob.  I just wasn't sure and I didn't want to take a chance.  Did you receive my email?

[Bob Gaines]

Thanks Bob.  I just wasn't sure and I didn't want to take a chance.  Did you receive my email?

Yes I did.