GT500 Engine gauge feed question

[acman63]

someone ordered this from one of the big Mustang vendors and I dont have any pics of the install.  does anyone have a pic or guidance on where the scotchlock  is installed and to what

[DennyD]

Jim, It would appear from your photo that the harness is missing one of it's feeds and the connector.

Look at this link:

https://www.amazon.com/Mustang-Engine-Gauge-Wiring-Block/dp/B00T815J44

[The Going Thing]

There is no scotch loks used on the engine feed. They are used for the inboard/outboard lamp extensions and under the dash to feel the oil/amp cluster. The original 1967 Shelby oil pressure sending unit wire was cut and folded over on itself with a piece of tape as well.

[Coralsnake]

Jim is this for a 1968 application?

This harness is also usedd for the 1968 Shelbys and does use a scotch lok

[Bob Gaines]

Jim is this for a 1968 application?

This harness is also usedd for the 1968 Shelbys and does use a scotch lok

+1. I think the package was mis marked as 67 or maybe  Scotch Loc was included so as to fit both 67 and 68. 

[Coralsnake]

Alloy marks all these harnesses the same, with the 1967 identification. Not mismarked, just used for multiple applications.

www.thecoralsnake.com/wiring

[Bob Gaines]

Alloy marks all these harnesses the same, with the 1967 identification. Not mismarked, just used for multiple applications.

www.thecoralsnake.com/wiring

I suppose that if not mis marked and used for both applications like I eluded to in my post that the addition of the wording like but not limited to "68 with scotch loc" would eliminate some confusion like it has in this instance .